Just got my Incra table saw fence set up after a month of not getting any woodworking done in the workshop. Installed JessEm feed rollers on top of the fence.
Okay, where do I start…
This is pure engineering porn.
I’ve a Bosch contractor table saw that was almost trued up straight out of the box, I just needed to adjust the angle of the saw blade by less than a quarter of a turn to make it cut accurately to within 1/1000 of a degree.
I installed an Incra Tools LS Positioner Table Saw Fence which is mind-boggling accurate. I’ve been cutting strips at a repeatable thickness of 1/64″ of an inch out of walnut and I am just floored by this.
On top of the table saw fence I’ve installed the JessEm feed rollers, and again, these little gadgets are so well engineered I am floored. The workmanship is amazing. Damn, those Canadian aerospace engineers know their shit.
Everything is installed and made accurate, I have been just playing with this setup so far, but I am lost of words at how awesome this configuration is.
The great thing is, because I have only a small workshop, when I need to move my table saw out of the way, I just flip the entire thing up on end and stash it against the wall.